CLICK HERE TO BUY : www.shavenation.com to Purchase Fine Shaving Products. Does your Water Heater ignitor glow, Produce Flame at Main Burner Assembly, then shut down and start the cycle over several times without staying on? If so Chances are the Flame Sensor is Covered with Oxidation or Residue . I will show you how to remove the Main Burner Assembly Sand off the residue form the Flame Sensor and Reinstall it so it will again work properly. Eliminating the TROUBLE Lights on the temperature control assembly.
Keywords: water, heater, flame, sensor, ignitor, igniter, repair, main, hot, cold, problem, burner, assembly, gas, valve, tube, sand, paper, anode, temperature, controller, short, cycle, goes, out, off, yellow, blue, 90%, efficient, efficiency, propane, heat, cool, thermocouple, residue, ao, smith, kenmore, ruud, rheem, sears, natural, electric, rv, home, fuel, trouble, code, light, how, to, hvac, troubleshoot, service, call, save, money, electricity, explosion, installation, piot, maintenance, thermostat, leaking, mythbusters, rocket
ไม่มีความคิดเห็น:
แสดงความคิดเห็น